HAPPY NEW YEAR FROM HRP

I am spending part of my New Years Weekend machining cases for our Derringer Top Fuel Stage 1 and Stage 2 engines on our Haas VF-4 machining center. It takes the Haas a little over 1 hour to completely machine the inside of one engine case half. To give you an idea of the material removed, this is equal to three – 55 gallon drums of chips in 6 hours of run time. Next step is to run the opposite side and then flip them over to machine the outer surface of each case half.

HAPPY NEW YEAR

About the author

Leave a Reply

Your email address will not be published. Required fields are marked *